I was testing out my Kickain yesterday in conjunction with the NerdSeq. The nerdseq has triggers of configurable length, starting with 5ms and working up in increments of 5 ms. I noticed I had to tweak this up (need to doublecheck the specific amount) in order to get the kickain to respond. Just wanted to confirm what the expected trigger length/height is (I didn't see it specified in the manual).
top of page
bottom of page
OK, I am getting stuck on the updating firmware. Using Chome, going to Daisey Web, connect with microUSB., push boot then reset, connect ... I don't see anything that is obvious a Daisey module but try to connect.
I never get the "Select, "DFU in FS Mode"". Tried updating drivers using Zadig. Any hints? I am on a Windows 11 machine.